Cher, Siang Tan and Yee, Ling Lee and Mohammad, Shahrin and Siong, Kang Lim and Yeong, Huei Lee and Jee, Hock Lim (2015) Flexural behaviour of reinforced slab panel system with embedded cold-formed steel frames as reinforcement. Jurnal Teknolgi, 74 (4). pp. 39-44. ISSN 2180-3722
|
PDF (Full Text)
1MB |
Official URL: http://dx.doi.org/10.11113/jt.v74.4607
Abstract
This paper presents the experimental investigation on flexural characteristic of slab panels with embedded cold-formed steel frame as reinforcement. Perforated cold-formed steel channel sections are formed into steel frames as replacement to the conventional reinforcement bars inside precast concrete slab panels. A series of six experimental specimens for precast slab panels were tested. The specimens with 3 configurations namely control sample (CS) with conventional reinforcement bars, single horizontal C-channel section (SH) and double horizontal C-channel sections (DH) formed into rectangular hollow section. Results show that the tested slab specimens failed at the flexural crack at mid-span, under loading point and shear at the support. Tearing of shear connector in the cold-formed steel section was found to be the main factor for the structural failure. SH specimens achieved the highest ultimate load capacity, with average value of 138.5 kN, followed by DH specimens, 116.5 kN, and the control samples, 59.0 kN. The results showed that the proposed reinforced slab panel with embedded cold-formed steel frame was more effective compared to conventional reinforced slab
Item Type: | Article |
---|---|
Uncontrolled Keywords: | cold-formed steel, perforated, precast, channel section |
Subjects: | T Technology > TA Engineering (General). Civil engineering (General) |
Divisions: | Civil Engineering |
ID Code: | 55321 |
Deposited By: | Fazli Masari |
Deposited On: | 24 Aug 2016 03:48 |
Last Modified: | 24 Aug 2016 03:48 |
Repository Staff Only: item control page