Universiti Teknologi Malaysia Institutional Repository

The effect of nodularisation parameters on the quality of ductile iron

Maarof, Mohd. Rashidi (2006) The effect of nodularisation parameters on the quality of ductile iron. Masters thesis, Universiti Teknologi Malaysia, Faculty of Mechanical Engineering.

[img] PDF (Fulltext)
Restricted to Repository staff only

[img] PDF (Abstract)
[img] PDF (Table Of Content)
[img] PDF (1st Chapter)

Official URL: http://dms.library.utm.my:8080/vital/access/manage...


Demand on plastic product in this country is very tremendous because plastic product has better in quality, design and appearance than any material product. To produce better quality of plastic product, it needs to have some processes and most important is initially in design stages. Because of that, plastic product can be produced using any different mold such as 2-plate mold, 3-plate mold, hot runner mold and insulated runner mold. Material flow analysis should be running to the plastic product to ensure no defect and follow the characteristics from actual specification. This project is using Moldflow Mold Adviser software to analyze the problems for 2-plate mold and 3-plate mold, which are dependent on sprue, runner and gate system.

Item Type:Thesis (Masters)
Additional Information:Thesis (Sarjana Kejuruteraan Mekanikal (Teknologi Pembuatan Termaju)) - Universiti Teknologi Malaysia, 2005; Supervisor : Dr. Mohd. Hasbullah Hj. Idris
Uncontrolled Keywords:plastic product, mold, material flow analysis
Subjects:T Technology > TJ Mechanical engineering and machinery
Divisions:Mechanical Engineering
ID Code:9504
Deposited By: Ms Zalinda Shuratman
Deposited On:31 Dec 2009 04:13
Last Modified:24 Mar 2015 07:43

Repository Staff Only: item control page