Mohd. Yaseen, Yasir Amzad Ali (2009) Developing PLC based gantry robot using positioning servo drive with profibus – dp communication protocol. Masters thesis, Universiti Teknologi Malaysia, Faculty of Electrical Engineering.
|
PDF
521kB |
Abstract
PLC (Programmable Logic Controller) is one of the most important device in industrial automation nowadays. PLC is the device which control the machine so that the machine can run fully automatically. PLC is rarely use to control movement of the axis. Usually axis movement will be controlled by CNC (Computer Numeric Controller) machines. But in this Project, PLC is used to control gantry robot with three axis using positioning servo drive and its communicate via PROFIBUS (Process Fieldbus). The reason that PLC used to control the robot is because, PLC based machine is relatively much cheaper compare to machine that use CNC.
| Item Type: | Thesis (Masters) |
|---|---|
| Additional Information: | Thesis (Sarjana Kejuruteraan (Elektrik - Mekatronik dan Kawalan Automatik)) - Universiti Teknologi Malaysia, 2009; Supervisor : Dr. Hazlina Selamat |
| Uncontrolled Keywords: | programmable logic devices, programmable logic controller, computer numeric controller |
| Subjects: | T Technology > TK Electrical engineering. Electronics Nuclear engineering T Technology > TL Motor vehicles. Aeronautics. Astronautics |
| Divisions: | Electrical Engineering |
| ID Code: | 12079 |
| Deposited By: | Liza Porijo |
| Deposited On: | 28 Feb 2011 04:39 |
| Last Modified: | 17 Sep 2017 10:19 |
Repository Staff Only: item control page
