Items where Year is 2017

Abas, M. A. and Wan Salim, W. S. and Ismail, M. I. and Rajoo, S. and Martinez-Botas, R. (2017) Fuel consumption evaluation of SI engine using start-stop technology. Journal of Mechanical Engineering and Sciences, 11 (4). pp. 2967-2978. ISSN 2289-4659

Abbasi, F. and Mehdipour-Ataei, S. and Tabatabaei-Yazdi, Z. and Babanzadeh, S. and Abouzari-Lotf, E. (2017) Effect of sepiolite nanoparticles on the properties of novel poly(sulfone ether imide). Polymers for Advanced Technologies, 28 (3). pp. 404-410. ISSN 1042-7147

Andrab, Syed Gous and Hekmat, Ali and Yusop, Zulkifli (2017) A review: evolutionary computations (GA and PSO) in geotechnical engineering. Computational Water, Energy, and Environmental Engineering, 6 (2). pp. 154-179. ISSN 2168-1562

Bashardoost, M. and Mohd. Rahim, M. S. and Saba, T. and Rehman, A. (2017) Replacement attack: a new zero text watermarking attack. 3D Research, 8 (1). ISSN 2092-6731

Chong, K. C. and Lai, S. O. and Lau, W. J. and Thiam, H. S. and Ismail, A. F. and Zulhairun, A. K. (2017) Fabrication and characterization of polysulfone membranes coated with polydimethysiloxane for oxygen enrichment. Aerosol and Air Quality Research, 17 (11). pp. 2735-2742. ISSN 1680-8584

Dhar, S. and Shukla, P. R. and Pathak, M. (2017) India's INDC for transport and 2 C stabilization target. Chemical Engineering Transactions, 56 . pp. 31-36. ISSN 2283-9216

Hui, K. H. and Ooi, C. S. and Lim, M. H. and Leong, M. S. and Al-Obaidi, S. M. (2017) An improved wrapper-based feature selection method for machinery fault diagnosis. PLoS ONE, 12 (12). ISSN 1932-6203

Izaiddin, M. A. S. and Mustaffa, A. F. and Padzillah, M. H. (2017) Investigation of torque generation capability of mixed flow turbine under steady state conditions. Jurnal Teknologi, 79 (7-3). pp. 105-112. ISSN 0127-9696

Jimbin, V. S. and Ahmad, N. A. (2017) Magnetic field measurement from 132/275 KV overhead power lines. Jurnal Teknologi, 79 (1). pp. 89-95. ISSN 0127-9696

Kamaludin, R. and Othman, M. H. D. and Kadir, S. H. S. A. and Rahman, M. A. and Jaafar, J. (2017) The morphological properties study of photocatalytic TiO2/PVDF dual layer hollow fiber membrane for endocrine disrupting compounds degradation. Malaysian Journal of Analytical Sciences, 21 (2). pp. 426-434. ISSN 1394-2506

Kamarudin, M. S. and Zulkeflee, M. and Padzillah, M. H. (2017) Effect of tip clearance on the flow field of the mixed flow turbocharger turbine. Jurnal Teknologi, 79 (7-3). pp. 97-103. ISSN 0127-9696

Kusworo, T. D. and Ismail, A. F. and Aryanti, N. and Widayat, Widayat and Qudratun, Qudratun and Utomo, D. P. (2017) Enhanced anti-fouling behavior and performances of nano hybrid PES-sio2 and pes-zno membranes for produced water treatment. Jurnal Teknologi, 79 (6). pp. 129-140. ISSN 0127-9696

Lertwittayanon, K. and Youravong, W. and Lau, W. J. (2017) Enhanced catalytic performance of Ni/Α-Al2O3 catalyst modified with CaZrO3 nanoparticles in steam-methane reforming. International Journal of Hydrogen Energy, 42 (47). pp. 28254-28265. ISSN 0360-3199

Li, X. and Nia, A. B. and Ma, X. and Yahya, M. Y. and Wang, Z. (2017) Dynamic response of Kevlar®29/epoxy laminates under projectile impact-experimental investigation. Mechanics of Advanced Materials and Structures, 24 (2). pp. 114-121. ISSN 1537-6494

Madhanagopal, J. and Singh, O. P. and Sornambikai, S. and Omar, A. H. and Sathasivam, K. V. and Fatihhi, S. J. and Abdul Kadir, M. R. (2017) Enhanced wide-range monotonic piezoresistivity, reliability of Ketjenblack/deproteinized natural rubber nanocomposite, and its biomedical application. Journal of Applied Polymer Science, 134 (25). ISSN 0021-8995

Mahmoudian, S. and Reza Sazegar, M. and Afshari, N. and Uzir Wahit, M. (2017) Graphene reinforced regenerated cellulose nanocomposite fibers prepared by lyocell process. Polymer Composites, 38 . E81-E88. ISSN 0272-8397

Muniandy, V. and Mohd. Samin, P. and Jamaluddin, H. and Abdul Rahman, R. and Abu Bakar, S. A. (2017) Double anti-roll bar hardware-in-loop experiment for active anti-roll control system. Journal of Vibroengineering, 19 (4). pp. 2886-2909. ISSN 1392-8716

Muslim, M. T. and Selamat, H. and Alimin, A. J. and Haniff, M. F. (2017) Manifold absolute pressure estimation using neural network with hybrid training algorithm. PLoS ONE, 12 (11). ISSN 1932-6203

Pour, A. B. and Hashim, M. (2017) Application of Landsat-8 and ALOS-2 data for structural and landslide hazard mapping in Kelantan, Malaysia. Natural Hazards and Earth System Sciences, 17 (7). pp. 1285-1303. ISSN 1561-8633

Saidi, H. and Uthman, H. (2017) Phosphoric acid doped polymer electrolyte membrane based on radiation grafted poly(1-vinylimidazole-co-1-vinyl-2-pyrrolidone)-g-poly(ethylene/tetrafluoroethylene) copolymer and investigation of grafting kinetics. International Journal of Hydrogen Energy, 42 (14). pp. 9315-9332. ISSN 0360-3199

Suriyanti, S. N. P. and Usup, G. (2017) Morphology and molecular phylogeny of the marine diatom nitzschia dentatum sp. nov and N. Johorensis sp. nov ( bacillariophyceae) from Malaysia. Bangladesh Journal of Plant Taxonomy, 24 (2). pp. 183-196. ISSN 1028-2092

Sykes, J. M. and Whyte, E. P. and Yu, X. and Sahir, Z. Sharer (2017) Does "coating resistance" control corrosion? Progress in Organic Coatings, 102 . pp. 82-87. ISSN 0300-9440

Tan, M. L. and Ibrahim, A. L. and Yusop, Z. and Chua, V. P. and Chan, N. W. (2017) Climate change impacts under CMIP5 RCP scenarios on water resources of the Kelantan River Basin, Malaysia. Atmospheric Research, 189 . pp. 1-10. ISSN 0169-8095

Tang, Z. S. and Bolong, N. and Saad, I. and Ismail, A. F. and Lim, F. T. Y. (2017) Response surface modeling of electrospinning parameters on titanium oxide nanofibers’ diameter: a Box-Behnken design (BBD). Advanced Science Letters, 23 (11). pp. 11237-11241. ISSN 1936-6612

Tran, M. V. and Scribano, G. and Chong, C. T. and Ho, T. X. (2017) Influence of hydrocarbon additions and dilutions on explosion behavior of syngas/air mixtures. International Journal of Hydrogen Energy, 42 (44). pp. 27416-27427. ISSN 0360-3199

Uthman, H. (2017) Recycling and characterisation of spent lubricating oil. International Journal of Environment and Waste Management, 19 (2). pp. 181-190. ISSN 1478-9876