Items where Subject is "T Technology > TG Bridge engineering"

A

Abd. Karim, Izian (2002) Behaviour of box girder LRT bridge under low intensity earthquake effect using fem analysis. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Adnan, Azlan and Alih, Sophia C. and Mirasa, Karim (2006) Bridge evaluation through nondestructive testing in comparison with visual inspection. In: 6th Asia-Pacific Structural Engineering and Construction Conference, 5-6 September 2006, Kuala Lumpur, Malaysia.

Adnan, Azlan (1998) Low intensity earthquake effects on steel girder bridges. PhD thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Ahmad, Suriati (2013) Analysis of a continuous multicellular curved bridge deck using grillage analogy method. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Alomar, Saif Laith Khalid (2009) Comparison between grillage model and finite element model for analyzing bridge deck. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Amiri, I. S. and Afroozeh, A. and Bahadoran, M. and Ali, J. and Yupapin, P. P. (2011) Molecular transporter system for qubits generation. Jurnal Teknologi (Sciences and Engineering), 55 (1). pp. 155-165. ISSN 0127-9696

Ang, May Ling (2000) The development of computer-aided system for quantitative assessment of deterioration effects in concrete bridges. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Ansari, Reza (2013) The characteristics of a sustainable bridge : a case study of Second Penang Bridge. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Argadan, Hanizah (2007) Repair and strengthening methods for bridge supports. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Azman Hambali, Mohd. Khairul (2012) Deflection monitoring of cast in-situ balanced cantilever prestressed concrete box girder bridge. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

B

Bakhary, Norhisham (2001) Application of artificial neural network in bridge deck condition rating. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Bakhary, Norhisham (2002) Application of artificial neural network in bridge deck condition rating. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Bakhteri, Jahangir and Makhtar, Ahmad Mahir (2003) Investigation of failure modes in unreinforced brick masonry walls subjected to different load combinations. Project Report. Universiti Teknologi Malaysia. (Unpublished)

C

Choon, Teck Kiang (2000) A comparison of bridge deck analysis techniques : grillage analysis and finite element method. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

F

Faqe Rahim, Aso Abdulghafur (2013) Comparison of analysis models for semi circular curved box-girder bridge deck. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

G

Ginto, Reno (1999) Anggaran awal perbelanjaan pembinaan jambatan struktur keluli. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

H

Hassan, Nik Ab. Hadi (2003) Study on failure of a new bridge over Sg. Kerawang, Pulai Chondong, Kelantan. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Ho, Jin How (2002) Life cycle cost analysis on corrosion remedial measures for concrete bridges. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

I

Ismail, Faridah (2000) Kajian terhadap perlaksanaan sistem "design and build" bagi projek jambatan. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Ismail, Zulhilmi (2001) Scour investigation around multiple bridge piers. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

J

Jatnika, Asep Wawan and Sinaga, Anggiat and Munaf, Dicky R. (2006) The construction of science and technology culture on the development of Suramadu bridge. In: 6th Asia-Pacific Structural Engineering and Construction Conference, 5-6 September 2006, Kuala Lumpur, Malaysia.

Jeevaragagam, Ponselvi (2001) Fuzzy logic assessments of bridge scour. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

K

Koo , Hong Kect (2004) Deflection profile check for a guyed monorail steel bridge. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

L

Lai , Chee Fong (2004) Wind loads on suspension bridge section using finite element analysis. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Lee, Poh Huat (2005) Case study to determine the camber of post- tensioned 'I' beam. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Lo, Seng Ling (2002) Diagnostic dynamic testing of bridges for structural integrity. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

M

Mohamad Bhkari, Norshariza (2005) Modal analysis of concrete bridge decks subjected to free vibration. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Mohmad, Munirah (2012) Aspects of analysis of simply supported bridge decks. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Muniandy, Gopinath (2010) Forensic engineering testing techniques for structural assesment : a case study on pre-stressed reinforced concrete bridge at Klang Valley. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

N

Nge, Siew Boon (2001) Geometric parametric study on concrete beam bridge. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

R

Ramli, Mohd. Zamri (2006) Response of existing rubber bearing and designed base isolator for malaysian highway bridges. In: 6th Asia-Pacific Structural Engineering and Construction Conference, 5-6 September 2006, Kuala Lumpur, Malaysia.

Ramli, Mohd. Zamri (2002) Seismic performance of prestressed highway bridge rubber bearing. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

S

Sadeghi, Faraz and Kueh, Ahmad Beng Hong and Vafaei, Mohamad Reza (2013) Dynamic response of composite footbridges under running pedestrian load. In: BEIAC 2013 - 2013 IEEE Business Engineering and Industrial Applications Colloquium.

Safiee, Nor Azizi (2004) Modelling of steel-concrete composite beam sections of bridges using finite element method. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Sambasivam, Pathmanathan (2004) Towards an effective bridge maintenance management system in Jabatan Kerja Raya Malaysia. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Sarker, Md. Akhtaruzzaman (1996) Flow investigation around bridge pier on a scoured bed. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Shafii, Faridah (1995) Modelling of shear in post-tensioned brickwork cantilever fin walls. Jurnal Kejuruteraan Awam, 8 (2). pp. 38-52. ISSN 0128-0147

Singh, Balvit (2002) Preprocessor program for analysis of concrete bridge deck. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Sockalingam, Mathivanan (1997) Study of structural integrity of a model steel bridge structure using ambient vibration method. Masters thesis, Universiti Teknologi Malaysia, Faculty of Mechanical Engineering.

Suhatril, M. (2011) The comparison of soil-pile interaction and fixed base support for integral prestressed concrete box-girder bridge. International Journal of Physical Sciences, 6 (28). pp. 6580-6595. ISSN 1992-1950

T

Teo, Mei Choo (2009) Attributes of smart bridge monitoring technologies. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

W

Wan Ahmad Kamal, Wan Ikram Wajdee (2005) Comparison of bridge design in Malaysia between American codes and British codes. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.

Y

Yap, Choy Keen (2002) Parametric study on the static behaviour of radiating-type steel cable-stayed bridges. Masters thesis, Universiti Teknologi Malaysia, Faculty of Civil Engineering.