Bahador, Abdollah and Umeda, Junko and Yamanoglu, Ridvan and Abu Bakar, Tuty Asma and Kondoh, Katsuyoshi (2021) Strengthening evaluation and high-temperature behavior of ti–fe–o–cu–si alloy. Materials Science and Engineering A, 800 . ISSN 0921-5093
Full text not available from this repository.
Official URL: http://dx.doi.org/10.1016/j.msea.2020.140324
Abstract
Fully dense powder metallurgy (PM) Ti–4Fe–0.2O–3Cu–0.4Si alloy was produced employing spark plasma sintering (SPS) and hot extrusion aiming to develop an inexpensive high strength dual-phase (α+β) Ti alloy. The microstructure consisted of globularized fine grain α phase dispersed in the β matrix having the sharp texture of [removed]//extrusion direction. The tensile strength of alloy (~1060 MPa) is comparatively higher than the conventional Ti–6Al–4V alloy produced by a similar method. Based on theoretical calculations the grain refinement and solid solution phenomena were the principal strengthening mechanisms. Additionally, it was found that Si solute remarkably enhanced the microstructure stability (using in situ EBSD observation) and yield strength of alloy at high-temperature.
| Item Type: | Article |
|---|---|
| Uncontrolled Keywords: | high-temperature stability, mechanical properties, powder metallurgy, ubiquitous alloys |
| Subjects: | T Technology > TJ Mechanical engineering and machinery |
| Divisions: | Mechanical Engineering |
| ID Code: | 94006 |
| Deposited By: | Yanti Mohd Shah |
| Deposited On: | 28 Feb 2022 13:31 |
| Last Modified: | 28 Feb 2022 13:31 |
Repository Staff Only: item control page
