Dehghani, D. and Yahya, Azli and Khamis, N. H. (2020) Dynamic behaviour of EDM system through mathematical model. In: 2nd Joint International Conference on Emerging Computing Technology and Sports, JICETS 2019, 25 November 2019 - 27 November 2019, Bandung, Indonesia.
|
PDF
976kB |
Official URL: http://dx.doi.org/10.1088/1742-6596/1529/5/052001
Abstract
Electrical discharge machining (EDM) is a stochastic machining process which widely used to generate dies and molds. However, information about the EDM process is still at the earlier stage which lead to experience many challenges for further developments. Experimental analysis is time consuming as well as a costly procedure, due to the highly stochastic and complex nature of the process. Therefore, process modeling is an alternative to reduce the experimental costs related to the technology. This research proposes method to design a mathematical model of electrical discharge machining (EDM) system. The model will be used to understand the effects of machining parameters into the dynamic behaviour of EDM system based on the sparking phases and pulse power generator.
| Item Type: | Conference or Workshop Item (Paper) |
|---|---|
| Uncontrolled Keywords: | EDM, process modeling, stochastic nature |
| Subjects: | T Technology > TK Electrical engineering. Electronics Nuclear engineering |
| Divisions: | Electrical Engineering |
| ID Code: | 91824 |
| Deposited By: | Yanti Mohd Shah |
| Deposited On: | 28 Jul 2021 08:47 |
| Last Modified: | 28 Jul 2021 08:47 |
Repository Staff Only: item control page
