Universiti Teknologi Malaysia Institutional Repository

Surface treatment on polymethylmethacrylate hybrid using argon flouride excimer laser

Bidin, Noriah and Zarzali Shah, Aishah and Mat Daud, Yaacob (2008) Surface treatment on polymethylmethacrylate hybrid using argon flouride excimer laser. Jurnal Fizik UTM, 3 . pp. 8-13. ISSN 0128-8644

[img] PDF (Fulltext) - Published Version
157kB

Abstract

Flatness and smoothness of optical components are crucial to maintain the uniformity of light distribution. However, to treat a very delicate surface require, a controllable and gentle technique. This can be achieved by using ultraviolet laser as a micromaching. In this case, an argon fluoride excimer laser was employed as a source of ablation. Polymethylmethacrylate (PMMA) film is coated on a Perspex substrate. Fabry-Perot interferometer was incorporated as a dynamic transducer to monitor the surface treatment. The Hybrid plastic-polymer was then ablated by series pulses of UV excimer laser. The pulses are controlled until the appearance of straight and equidistance line fringes. The degree of flatness achieved by using this laser surface treatment is ?/10.

Item Type:Article
Uncontrolled Keywords:flatness, excimer, polymethylmethacrylate, Fabry-Perot interferometer, fabrication phase control
Subjects:Q Science > QC Physics
Divisions:Science
ID Code:8564
Deposited By: Norshiela Buyamin
Deposited On:30 Apr 2009 05:22
Last Modified:28 Jun 2013 03:43

Repository Staff Only: item control page