Abd. Halim, M. A. and Mohd., N. A. R. N. and Mohd. Nasir, M. N. and Dahalan, M. N. (2018) The evaluation of k-ε and k-ω turbulence models in modelling flows and performance of S-shaped diffuser. International Journal of Automotive and Mechanical Engineering, 15 (2). pp. 5161-5178. ISSN 2229-8649
|
PDF
523kB |
Official URL: http://dx.doi.org/10.15282/ijame.15.2.2018.2.0399
Abstract
Diffusing S-shaped ducts are critical components in modern vehicle, primarily employed in directing the airflow to the engine. It links the air box and the engine in a very restricted place. The air flow through an S-duct is complex in nature, which perhaps includes boundary layer separation, secondary flow, and total pressure loss effects that influences the engine performance. In this work, the flow and performance of S-shaped duct was predicted and analysed using computational fluid dynamics. The main objective is to evaluate the performance of the realizable k-ε and k-ω SST models qualitatively and quantitatively in modelling flow of a highly bend duct where a high stress distorted flow may have developed in proximity the duct wall leading to stall. CFD computations were performed for the flow entering the diffuser at Reynolds number of 80,000 cases. The results obtained suggested that the k-ω SST model reasonably predicts the flow characteristics qualitatively and quantitatively. The realizable k-ε turbulence model however poorly captures the actual magnitudes of the calculated flow features. The growth of the stream-wise velocity profile was calculated at three stream-wise stations and point out a smooth down the interior profile of the divergent section. An extreme flow distortion and a shift of the region of flow with the highest velocity were developed toward the outer wall of the first bend of the diffuser. A significant pressure recovery potential with no flow separation arise over the diffuser tube range was predicted well by the simulations.
Item Type: | Article |
---|---|
Uncontrolled Keywords: | CFD, Conical, Performance, S-shaped diffuser, Validation |
Subjects: | T Technology > TJ Mechanical engineering and machinery |
Divisions: | Mechanical Engineering |
ID Code: | 79724 |
Deposited By: | Fazli Masari |
Deposited On: | 28 Jan 2019 06:37 |
Last Modified: | 28 Jan 2019 06:37 |
Repository Staff Only: item control page