Universiti Teknologi Malaysia Institutional Repository

Initial study of a wire mesh tomography sensor for liquid/gas component investigation

Rahiman, Mohd. Hafiz Fazalul and Siow, Lean Thiam and Abd. Rahim, Ruzairi and Zakaria, Zulkarnay and Ang, Vernoon (2015) Initial study of a wire mesh tomography sensor for liquid/gas component investigation. Journal of Electrical Engineering and Technology, 10 (5). pp. 2205-2210. ISSN 1975-0102

Full text not available from this repository.

Official URL: http://dx.doi.org/10.5370/JEET.2015.10.5.2205

Abstract

Experimental studies have been carried out to study the principle operation of the conductive type wire-mesh tomography sensor and analyse the wire-mesh tomography sensor for the liquid/gas two-phase flow interface and void fraction distribution in a process column. The measurement of the two-phase flows in the process column is based on the cross-sectional local instantaneous conductivity. The sensor consists of two planes of parallel electrode wires with 16 electrodes each and was placed orthogonally with each plane. The sensor electrode wires were made of tinned copper wire with an outer diameter of 0.91 mm which stretched over the sensor fixture. Therefore, this result in the mesh grid size with 5 53×5.53mm2. The wire-mesh sensor was tested in a horizontal liquid/gas two-phase flows process column with nominal diameter of 95.6 mm and the sampling frequency of 5882.3529 Hz. The tomogram results show that the wire-mesh tomography provides significant results to represent the void fraction distribution in the process column and estimation error was found in the liquid/gas interface level

Item Type:Article
Uncontrolled Keywords:wire-mesh sensor, wire-mesh tomography
Subjects:T Technology > TK Electrical engineering. Electronics Nuclear engineering
Divisions:Electrical Engineering
ID Code:55962
Deposited By: Fazli Masari
Deposited On:15 Nov 2016 06:25
Last Modified:05 Sep 2017 07:01

Repository Staff Only: item control page