Mansourizadeh, A. and Ismail, Ahmad Fauzi and Abdullah, M. S. and Ng, B. C. (2010) Preparation of polyvinylidene fluoride hollow fiber membranes for CO2 absorption using phase-inversion promoter additives. Journal of Membrane Science, 355 (1-2). 200 -207. ISSN 0376-7388
Full text not available from this repository.
Official URL: http://dx.doi.org/10.1016/j.memsci.2010.03.031
Abstract
Porous polyvinylidenefluoride (PVDF) hollowfibermembranes were fabricated via a wet phase-inversion method. Ortho-phosphoric acid and lithium chloride monohydrate (LiCl·H2O) were used as phase-inversionpromoteradditives in the spinning dopes. Ternary phase diagram of the polymer dopes were obtained using cloud point test. The membranes morphology was examined by field emission scanning electron microscopy (FESEM). The prepared membranes were characterized in terms of gas permeation, critical water entry pressure, overall porosity, contact angle and mass transfer resistance. Cloud point data showed that both additives increased precipitation rate of the spinning dopes significantly. From the FESEM examination, the hollowfibermembranes possess an ultra-thin outer skin layer with a thin finger-like layer beneath and a thick sponge-like sub-layer. Results of gas permeation test revealed that phosphoric acid resulted in the membranes with a larger mean pore size than PVDF + LiCl·H2O membrane. In addition, phosphoric acid in the spinning dope provided the hollowfibermembrane structure with significantly enhanced CO2 flux, which is approximately 33% more than the CO2 flux of the PVDF + LiCl·H2O membrane and the commercial PTFE membrane at 320 mL/min absorbent flow rate. Therefore, it can be concluded that an improved PVDF membrane structure prepared by phase-inversion process can be a cost-effective alternative for CO2absorption in gas–liquid membrane contactors.
Item Type: | Article |
---|---|
Uncontrolled Keywords: | CO2 absorption, Non-solvent additives |
Subjects: | Q Science > QD Chemistry |
Divisions: | Petroleum and Renewable Energy Engineering |
ID Code: | 26620 |
Deposited By: | Widya Wahid |
Deposited On: | 18 Jul 2012 03:36 |
Last Modified: | 09 Nov 2018 08:09 |
Repository Staff Only: item control page