Universiti Teknologi Malaysia Institutional Repository

Incorporating design for manufacture and assembly methodologies into the design of a modified spark plug

Che Zainal Abidin, Nik Mohd Farid (2007) Incorporating design for manufacture and assembly methodologies into the design of a modified spark plug. Masters thesis, Universiti Teknologi Malaysia, Faculty of Mechanical Engineering.

[img] PDF (Abstract)
31Kb
[img] PDF (Table Of Content)
32Kb
[img] PDF (1st Chapter)
25Kb
[img] PDF (References)
11Kb

Abstract

Air Pressure Plug is a product that can be used to inflate the inflatable items using the air from the internal combustion engine, which is channeled out using this device. This product is a good design to be commercialized. However, before releasing to the market, the product has to be cheap and good quality. Therefore, to achieve this goal, design for manufacture and assembly methodologies are used to evaluate the design of the product. Specifically, DFMA, which is Boothroyd- Dewhurst based software, and TeamSET, which is based on Lucas-Hull, are used to evaluate the product. The results for both analyses are compared to look for any variation in term of parts to be eliminated and combined.

Item Type:Thesis (Masters)
Additional Information:Supervisor :Tuan Haji Dr. Ariffin bin Abdul Razak
Uncontrolled Keywords:air pressure plug, internal combustion engine
Subjects:T Technology > TJ Mechanical engineering and machinery
Divisions:Mechanical Engineering
ID Code:9442
Deposited By: Ms Zalinda Shuratman
Deposited On:24 Nov 2009 01:52
Last Modified:23 Feb 2014 03:23

Repository Staff Only: item control page