Universiti Teknologi Malaysia Institutional Repository

Influence of pre-treatment temperature of palm oil fuel ash on the properties and performance of green ceramic hollow fiber membranes towards oil/ water separation application

Tai, Zhong Sheng and Hubadillah, Siti Khadijah and Othman, Mohd. Hafiz Dzarfan and Mohamed Dzahir, Mohd. Irfan Hatim and Koo, Khong Nee and Izadin Tendot, Nur Izzati Syaheerah Tendot and Ismail, Ahmad Fauzi and A. Rahman, Mukhlis and Jaafar, Juhana and Abd. Aziz, Mohd. Haiqal (2019) Influence of pre-treatment temperature of palm oil fuel ash on the properties and performance of green ceramic hollow fiber membranes towards oil/ water separation application. Separation and Purification Technology, 222 . pp. 264-277. ISSN 1383-5866

Full text not available from this repository.

Official URL: http://dx.doi.org/10.1016/j.seppur.2019.04.046

Abstract

Palm oil fuel ash (POFA) is one of the most abundant industrial wastes in palm oil producing countries like Indonesia and Malaysia. Due to its unique characteristics such as high silica and hydroxyl group contents, it has high potential to be used as the main material for the fabrication of low cost and green ceramic hollow fiber membrane. This work investigated the effect of pre-treatment temperature of POFA towards the properties of the derived ceramic hollow fiber membranes. The properties of POFA such as morphology, mineralogical and chemical composition, thermal behavior, surface and pore properties were analyzed through scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray fluorescence (XRF), carbon element analysis, energy dispersive X-ray spectroscopy (EDX), X-ray diffraction (XRD), thermogravimetric analysis (TGA) and nitrogen (N2) sorption technique. Effect of POFA pre-treatment temperature on the membrane properties were evaluated and characterized in terms of morphology, bending strength, pore size distribution, porosity and pure water flux (PWF). Finally, the separation performance of the membranes was also investigated using oil/water emulsion filtration tests. The results showed that the membrane properties were significantly improved for the membranes derived from pre-treated POFA compared to the untreated one. The highest bending strength of ∼60 MPa was achieved for TP700 membrane which was pre-treated at 700 °C. However, the PWF decreased from 219.2 to 28.4 L/m2 h for untreated POFA (UP) derived and TP700 membranes, respectively. Besides, an enhanced oil/water separation performance was obtained for membranes fabricated from pre-treated POFA with the highest oil rejection of 88.9%. These results showed that POFA derived ceramic hollow fiber membrane could provide the basis for the development of low cost and green ceramic hollow fiber membranes from waste ash for separation applications.

Item Type:Article
Uncontrolled Keywords:ceramic membrane, characterization, hollow fiber
Subjects:T Technology > TP Chemical technology
Divisions:Chemical and Energy Engineering
ID Code:89227
Deposited By: Yanti Mohd Shah
Deposited On:22 Feb 2021 06:07
Last Modified:22 Feb 2021 06:07

Repository Staff Only: item control page