Universiti Teknologi Malaysia Institutional Repository

Channel characterization and path loss modeling in indoor environment at 4.5, 28, and 38ghz for 5g cellular networks

Majed, Mohammed Bahjat and Abd. Rahman, Tharek and Abdul Aziz, Omar and Hindia, Mohammad Nour and Hanafi, Effariza (2018) Channel characterization and path loss modeling in indoor environment at 4.5, 28, and 38ghz for 5g cellular networks. International Journal of Antennas and Propagation, 2018 (914236). pp. 1-14. ISSN 1687-5869

[img]
Preview
PDF
872kB

Official URL: http://dx.doi.org/10.1155/2018/9142367

Abstract

The current propagation models used for frequency bands less than 6 GHz are not appropriate and cannot be applied for path loss modeling and channel characteristics for frequency bands above 6 GHz millimeter wave (mmWave) bands, due to the difference of signal propagation characteristics between existing frequency bands and mmWave frequency bands. Thus, extensive studies on channel characterization and path loss modeling are required to develop a general and appropriate channel model that can be suitable for a wide range of mmWave frequency bands in its modeling parameter. This paper presents a study of well-known channel models for an indoor environment on the 4.5, 28, and 38 GHz frequency bands. A new path loss model is proposed for the 28 GHz and 38 GHz frequency bands. Measurements for the indoor line-of-sight (LOS) and non-line-of-sight (NLOS) scenarios were taken every meter over a separation distance of 23m between the TX and RX antenna locations to compare the well-known and the new large-scale generic path loss models. This measurement was conducted in a new wireless communication center WCC block P15a at Universiti Teknologi Malaysia UTM Johor, Malaysia, and the results were analyzed based on the well-known and proposed path loss models for single-frequency and multifrequency models and for directional and omnidirectional path loss models. Results show that the large-scale path loss over distance could be modeled better with good accuracy by using the simple proposed model with one parameter path loss exponent PLE (n) that is physically based to the transmitter power, rather than using the well-known models that have no physical base to the transmitted power, more complications (require more parameters), and lack of anticipation when explaining model parameters. The PLE values for the LOS scenario were 0.92, 0.90, and 1.07 for the V-V, V-H, and V-Omni antenna polarizations, respectively, at the 28 GHz frequency and were 2.30, 2.24, and 2.40 for the V-V, V-H, and V-Omni antenna polarizations, respectively, at the 38 GHz frequency.

Item Type:Article
Uncontrolled Keywords:path loss exponent, separation distances, wireless communications
Subjects:T Technology > TK Electrical engineering. Electronics Nuclear engineering
Divisions:Electrical Engineering
ID Code:84606
Deposited By: Yanti Mohd Shah
Deposited On:27 Feb 2020 03:20
Last Modified:27 Feb 2020 03:20

Repository Staff Only: item control page