Universiti Teknologi Malaysia Institutional Repository

The Effect of Multiple Pass Cutting on Surface Integrity when Hard Turning of AISI D2 Cold Work Tool Steel

Kamely, M. A. and Noordin, M. Y. and Venkatesh, V. C. (2007) The Effect of Multiple Pass Cutting on Surface Integrity when Hard Turning of AISI D2 Cold Work Tool Steel. International Journal of Precision Technology, 1 (1). pp. 97-105. ISSN 1755-2060

Full text not available from this repository.

Official URL: http://dx.doi.org/10.1504/IJPTECH.2007.015348

Abstract

A judicious choice of insert material, tool geometry and cutting conditions can make hard turning produce better surfaces than grinding. AISI D2 is the most extensively used cold work tool steel in the tool and die industry. This steel of 60 HRC hardness was turned with PVD TiN coated ceramic tools (Al2O3/TiCN). Intragranular cracks were observed with single pass turning, while transgranular cracks occurred with multiple pass turning that was also accompanied by an increase in compressive stresses. In both passes, the white layer was observed, but in single pass, there was no subsurface deformed grain orientation, whereas in multiple passes, there was a distinct orientation.

Item Type:Article
Uncontrolled Keywords:hard turning; AISI D2; ceramic; multiple pass cutting; surface integrity
Subjects:T Technology > TJ Mechanical engineering and machinery
Divisions:Mechanical Engineering
ID Code:6572
Deposited By: Mohamad Ali Duki
Deposited On:26 Sep 2008 02:38
Last Modified:22 Oct 2017 01:49

Repository Staff Only: item control page