Universiti Teknologi Malaysia Institutional Repository

Copper/Nickel/Manganese doped cerium oxides based catalysts for hydrogenation of CO2

Toemen, Susilawati and Wan Abu Bakar, Wan Azelee and Ali, Rusmidah (2014) Copper/Nickel/Manganese doped cerium oxides based catalysts for hydrogenation of CO2. Bulletin of the Korean Chemical Society, 35 (8). pp. 2349-2356. ISSN 0253-2964

[img]
Preview
PDF
5MB

Official URL: http://dx.doi.org/10.5012/bkcs.2014.35.8.2349

Abstract

The recycling technology by the catalytic conversion is one of the most promising techniques for the CO2 treatment of coal burning power plant flue gases. The conversion of CO2 to valuable product of CH4 can be used as a fuel to run the turbine for electricity generation. Through this technique, the amount of coal needed for the combustion in a gas turbine can be reduced as well as CO2 emissions. Therefore, a series of catalysts based on cerium oxide doped with copper, nickel and manganese were prepared by impregnation method. From the characterization analysis, it showed that the prepared catalysts calcined at 400 °C were amorphous in structure with small particle size in the range below 100 nm. Meanwhile, the catalyst particles were aggregated and agglomerated with higher surface area of 286.70 m2g-1. By increasing the calcination temperature of catalysts to 1000 °C, the particle sizes were getting bigger (> 100 nm) and having moderate crystallinity with lower surface area (67.90 m2g-1). From the catalytic testing among all the prepared catalysts, Mn/Ce-75/Al2O3 calcined at 400 °C was assigned as the most potential catalyst which gave 49.05% and 56.79% CO2 conversion at reaction temperature of 100 °C and 200 °C, respectively

Item Type:Article
Uncontrolled Keywords:carbon dioxide, catalyst, coal burning power plant, flue gas, hydrogenation
Subjects:Q Science
Divisions:Science
ID Code:52238
Deposited By: Siti Nor Hashidah Zakaria
Deposited On:01 Feb 2016 03:54
Last Modified:17 Sep 2018 04:01

Repository Staff Only: item control page