Yahya, Azli and Andromeda, Trias and Minhat, Ade Erawan and Khamis, Nor Hisham and Khalil, Kamal and Abdul Rahim, Muhammad Arif (2012) Comparison studies of electrical discharge machining (EDM) process model for low gap current. Advanced Materials Research, 433-44 . pp. 650-654. ISSN 1662-8985
Full text not available from this repository.
Official URL: http://dx.doi.org/10.4028/www.scientific.net/AMR.4...
Abstract
This paper aims to compare the material removal rate, V between a Dimensional Analysis (DA) model, an Artificial Neural Network (ANN) model and an experimental result for a low gap current of an Electrical Discharge Machining (EDM) process. The data analysis is based on a copper electrode and steel workpiece materials. The DA and ANN model that have been developed and reported earlier by authors are used to compare the material removal of EDM process. The result indicated that the ANN model provides better accuracy towards the experimental results.
| Item Type: | Article |
|---|---|
| Additional Information: | Volumes : 433-440 |
| Uncontrolled Keywords: | Artificial Neural Network (ANN), dimensional analysis, Electrical Discharge Machining (EDM), MRR |
| Subjects: | T Technology > TK Electrical engineering. Electronics Nuclear engineering |
| Divisions: | Electrical Engineering |
| ID Code: | 31628 |
| Deposited By: | Fazli Masari |
| Deposited On: | 22 May 2013 06:55 |
| Last Modified: | 17 Mar 2019 04:02 |
Repository Staff Only: item control page
