Mohamed Yatim, Abdul Halim and Najafi, E. (2010) A D-STATCOM based on goertzel algorithm for sag detection and a novel current mode controller. In: The 5th IEEE Conference on Industrial Electronics and Applications (ICIEA 2010), 15-17 Jun 2010, Taichung, Taiwan.
Official URL: http://dx.doi.org/10.1109/ICIEA.2010.5515762
STATCOM has been widely proposed for power quality and network stability improvement. It is easily connected in parallel to the electric network and has many advantages for electrical grids. It can improve network stability; power factor, power transfer rating and can avoid some disturbances such as sags and swells. Most of STATCOM controllers are based on voltage controllers that are based on balance d-q transform. However, they are not thorough solutions for network disturbances since in most cases single-phase disturbances occur in electrical networks that cannot be avoided by the conventional controllers. This paper proposes a new current mode controller to overcome the mentioned problem. The approach uses a fixed frequency current controller to maintain voltage levels in sags and swells. This approach is also simple and can be easily implemented by digital signal processing. It has superior performance over conventional methods in terms of harmonic reduction in STATCOM output current. Another important factor for STATCOM effectiveness in sag mitigation is its sag detection method. This paper also introduces a new sag detection method based on Goertzel algorithm. The simulation results presented illustrate the superiority of the proposed controller and sag detection algorithm to be utilized in STATCOM.
|Item Type:||Conference or Workshop Item (Paper)|
|Uncontrolled Keywords:||goertzel algorithem, STATCOM, current control, power quality, sag|
|Subjects:||T Technology > TK Electrical engineering. Electronics Nuclear engineering|
|Deposited By:||Liza Porijo|
|Deposited On:||12 Jun 2012 08:23|
|Last Modified:||12 Jun 2012 08:23|
Repository Staff Only: item control page