Halim , Shamsul Azwan (2010) Simulation of plastic injection moulding part using moldflow and design of experiment. Masters thesis, Universiti Teknologi Malaysia, Faculty of Mechanical Engineering.
Full text not available from this repository.
| Item Type: | Thesis (Masters) |
|---|---|
| Additional Information: | Supervisors : Assoc. Prof. Dr. Hamidon Musa Rozaimi Mohd. Saad; Thesis (Sarjana Kejuruteraan (Mekanikal - Teknologi Pembuatan Termaju)) - Universiti Teknologi Malaysia 2010 |
| Subjects: | T Technology > TJ Mechanical engineering and machinery |
| Divisions: | Mechanical Engineering |
| ID Code: | 16686 |
| Deposited By: | Zalinda Shuratman |
| Deposited On: | 17 May 2021 07:24 |
| Last Modified: | 17 May 2021 07:24 |
Repository Staff Only: item control page
