Mandal, Nirmal Kumar and Rahman, Roslan Abd. and Leong, Mohd Salman (2005) Experimental investigation of vibration power flow in thin technical orthotropic plates by the method of vibration intensity. Journal of Sound and Vibration, 285 . pp. 669-695. ISSN 0022460X
Full text not available from this repository.
Official URL: http://dx.doi.org/10.1016/j.jsv.2004.08.041
Vibration intensity technique is used to measure vibration power transmission in thin single layer technical orthotropic plates for flexural waves. Measurement of flexural wave power is carried out in far-field conditions. All measurements are undertaken in the frequency domain using the cross-spectra of acceleration signals, facilitating the use of FFT analyzer. The two-transducer technique applicable to these plates is used for these measurements. Technical orthotropic (rectangular corrugation) plates of steel are used for the measurements. One isotropic plate of steel is also considered for comparison. Method of elastic equivalence technique is used. Both input power and vibration power transmission through the plates are estimated. Far-field power is normalized with the input power for flexural wave. Influence of flexural rigidity on vibration energy transfer is also investigated.
|Uncontrolled Keywords:||acceleration measurement, bending strength, elasticity, energy transfer, finite difference method, plates (structural components), transducers, isotropic plates, orthotropic plates, vibration intensity, vibration power flow, vibration measurement|
|Subjects:||Q Science > Q Science (General)|
T Technology > TA Engineering (General). Civil engineering (General)
|Deposited By:||S.N.Shahira Dahari|
|Deposited On:||01 Jun 2011 09:50|
|Last Modified:||13 Jun 2011 06:04|
Repository Staff Only: item control page