Universiti Teknologi Malaysia Institutional Repository

Leakage current characteristics in estimating insulator reliability: experimental investigation and analysis

Salem, Ali Ahmed and Lau, Kwan Yiew and Wan Rahiman, Wan Rahiman and Abdul Malek, Zulkurnain and Al-Gailani, Samir Ahmed and Abd. Rahman, Rahisham and Al-Ameri, Salem (2022) Leakage current characteristics in estimating insulator reliability: experimental investigation and analysis. Scientific Reports, 12 (1). pp. 1-21. ISSN 2045-2322

[img] PDF
823kB

Official URL: http://dx.doi.org/10.1038/s41598-022-17792-x

Abstract

The monitoring of leakage current (LC) and voltage characteristics in transmission line insulators is regarded as a good technique for anticipating the physical state of in-service insulators. In the current work, the temporal and frequency characteristics of LC and voltage under various situations were derived for assessing the health condition of porcelain, glass, and silicone rubber insulators. The contamination severity indicated by soluble deposit density, wetting level (Wt), non-soluble deposit density, and uneven pollution distribution (Pu/PL) were chosen as the environmental factors that impact the insulators. Six criteria were utilized to evaluate the physical state of the insulators, with four of those derived from the LC signal in the time domain, namely, the LC signal peak (C1), the phase shift between applied voltage and LC (C2), the LC signal slope between two consecutive peaks (C3), and the crest factor (C4). The remaining two indices, namely, the total harmonics distribution (C5) and the harmonics ratio indicator (C6), were obtained from the frequency domain of the LC signal. In addition, the flashover voltage index (C7) was also employed. The LC indicators were then classified based on the laboratory test results to reflect the physical state of the insulators. The findings revealed that the proposed indicators had an important impact in determining the physical state of the insulators. Furthermore, a confusion matrix was created for the test and prediction data using the suggested indicators to determine the effectiveness of each indicator.

Item Type:Article
Uncontrolled Keywords:LC signal, LC indicators, insulators
Subjects:T Technology > TK Electrical engineering. Electronics Nuclear engineering
Divisions:Faculty of Engineering - School of Electrical
ID Code:103991
Deposited By: Yanti Mohd Shah
Deposited On:09 Jan 2024 00:46
Last Modified:09 Jan 2024 00:46

Repository Staff Only: item control page