Juneja, Shahbaz and Chohan, Jasgurpreet Singh and Kumar, Raman and Sharma, Shubham and Rushdan, Ahmad Ilyas and M. Asyraf, M. R. and Razman, M. R. (2022) Impact of process variables of acetone vapor jet drilling on surface roughness and circularity of 3D-printed abs parts: fabrication and studies on thermal, morphological, and chemical characterizations. Polymers, 14 (7). pp. 1-28. ISSN 2073-4360
![]() |
PDF
1MB |
Official URL: http://dx.doi.org/10.3390/polym14071367
Abstract
Ever since the introduction of 3D printing, industries have seen an exponential growth in production and efficiency. Three-dimensional printing is the process of additive manufacturing (AM) in which the conventional method of material removal is challenged. Layer-on-layer deposition is the basic principle of the AM. Additive manufacturing technologies are used to create 3D-printed objects. An object is built in an additive technique by laying down successive layers of material until the object is complete. Each of these layers can be viewed as a cross-section of the item that has been lightly cut. When compared to traditional production methods, 3D printing allows the creation of complicated shapes with less material. In conventional methods, the materials go through several damages due to the tool–workpiece contact creating friction between them and the dissipated heat that damages the material. Overcoming the conventional method of machining with the help of 3D printing is a new advancement in the industries. The process involves using non-conventional methods for the machining of the parts. This research was oriented towards the chemical vapor jet drilling of the acrylonitrile–butadiene–styrene (ABS) materials. ABS materials are highly machinable and can be recycled for further usage. This paper focused on the usage of acetone as the chemical for drilling. The surface roughness and circularity of the drilled hole was taken into account for this research paper. We set up a manual experiment to run tests and get results. A vapor jet machine was designed with acetone as the core for the vapor. Various analyses were also formulated and conducted during experimentations. Surface roughness analysis provided the insight of roughness after the machining with the help of acetone vapor jet spray. SEM and micro-image parameters were also considered for more clear and advanced reports. In this research paper, DSC and FTIR analysis were performed to understand changes in the internal structure and the material properties of the ABS. Moreover, the research aimed to investigate the effect of various inputs processing parameters such as pressure, flow rate, and stand-off distance on the surface roughness and circularity of ABS workpiece material. The Taguchi L9 orthogonal array design was utilized to conduct tests by chemical vapor jet drilling using acetone and to evaluate the performance of the set-up while reducing the influence of interfering factors in order to provide reliable surface finish and circularity results. The results and conclusion of the research paper aimed to determine the most suitable parameters for the non-conventional acetone vapor jet drilling of the ABS material. The theoretical calculations predicted 1.64432 and 0.3289080 values of surface roughness and circularity, respectively. On the other hand, the experimental values were recorded as 1.598 for surface roughness and 0.322 for circularity. Therefore, a negligible error of 0.046 for surface roughness and 0.0031 for circularity, respectively, was noted which validate the statistical equations and the consistency of the combined vapor jet drilling process.
Item Type: | Article |
---|---|
Uncontrolled Keywords: | acrylonitrile–butadiene–styrene, additive manufacturing, chemical vapor jet drilling, DSC analysis, FTIR analysis, L9 Taguchi orthogonal array, SEM analysis, Surface roughness and circularity |
Subjects: | Q Science > Q Science (General) |
Divisions: | Chemical and Energy Engineering |
ID Code: | 103833 |
Deposited By: | Yanti Mohd Shah |
Deposited On: | 01 Dec 2023 01:51 |
Last Modified: | 01 Dec 2023 01:51 |
Repository Staff Only: item control page